The pins 1, 2, 9 and 10 are connected to the cable shield. You may connect the lenovo front panel into a generic motherboard using only the pins 3 to 12. It's a standard internal USB connector, but with two additional ground wires So I was googling a bit yesterday looking for additional info on this pinout and someone on the Lenovo Forums had a similar question about their Thinkcentre A60 front panel and front USB pinouts. Here's the wires connected to the old HP xw6200 board I did google a bit, but didn't have much luck getting any info. Since the info I had was for a HP board and now I'm going to use a Lenovo board. I didn't want to just assume it'd connect to the same pins. When the HP board was in the case I had those wires connected to the pins listed below. I'm good with the majority of the connections, but I'm not sure which pins to connect the HD activity light, + - led's, power button and reset button wires to? I previously had a HP xw6200 board in the case and used it as my desktop PC. So I figured, why not combine them and upgrade!!! The Lenovo board will be newer / better / faster and the Cooler Master case will allow me to fit more HD's inside. I have the Lenovo m700 and the Cooler Master case sitting around. But I want to upgrade before this old hardware starts to fail and give me problems. I currently have a HP dc7600 motherboard as my server running WHS 2011 in a generic case. Hopefully I can get some info as I start this swap!!! Hello, I'm looking for some assistance with getting a Lenovo Thinkcentre m700 motherboard wired up in a Cooler Master case.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
May 2023
Categories |